Home > Installation Instructions for Fontana Reno Wall Mounted Gold Rainfall Mixer Shower Set

How to install Fontana Reno Wall Mounted Gold Rainfall Mixer Shower Set | FS9567


Easy step by step Installation Instructions for Fontana Thermostatic Rain Waterfall Shower Set

  • Before you begin, please read the installation instructions below. Observe all local building and safety codes.
  • Unpack and inspect the product for any shipping damages. If you find damages, do not install.
  • Please note all showers must be installed by a professional and certified plumber otherwise warranty might be voided.
shower Fontana Reno Wall Mounted Gold Rainfall Mixer Shower Set

Shower Head Installation Instructions






Step 1: Step 2:

shower
Open the top cover and drill according to the marked position.
1. Mark by the position of the four holes.
2. Take care to avoid wires and pipes to prevent damage.
3. Be sure to confirm that the four holes are on the same horizontal line.
Remove the protective cover (F). Mark the positions and drill holes to suit the anchors (A). Install the anchors (A) and fix the rough-in valve (B) into the wall with screws. Use a level to ensure that the rough-in valve (B) is straight and level. (Important: Flush the water supply to remove any dirt and debris before installing the valve body).
Shower Head Installation Instructions
Step 3: Step 4:
Wrap Teflon tape around the pipe threads and connect water supply lines and in-wall pipes (not included) as desired to the rough-in valve (B). Turn on the water supply and open the cartridge to check for leakage. Then put on the protective cover and finish the wall surrounding the valve. (Note: Test the water pressure after the pipe connections have been made and before the finished wall material is installed). Two inlet fittings are connected to the pipe joint of the wall; then the nut, expansion screw, and inlet pipe are connected.





Shower Head Installation Instructions
Step 5: Step 6:

Reinstall the top cover.
Fix the escutcheon (D) to the showerhead (E) with screws (C).
Shower Head Installation Instructions

Step 7:

Remove the protective cover when the finished wall is completed. Then, install the showerhead (E) and press it against the finished wall.
Shower Head Installation Instructions


Shower Head Installation Instructions





Hand Held Shower Installation Instructions


Elbow Size Step 1:
Hand
Held
Shower
Hand
Held
Shower

Handheld Shower
Step 2: Step 3:
Handheld Shower
Step 4: Hand Shower Size: