How to install a dark oil rubbed bronze Bravat shower set
Installation Instructions Bravat Dark Oil Rubbed Bronze Shower Set With Valve Mixer 3-Way Concealed Wall Mounted
Before you begin, please read the installation instructions below. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you find damages, do not install.
Please note all showers must be installed by a professional and certified plumber otherwise warranty might be voided.
shower
Shower Head Installation Instructions
shower
Shower Head Parts Included:
Wall Mounting Arm
Locking nut
Wall trim
Shower arm
Showerhead Fixing screws
and wall plugs (not shown
Step 1:
Step 2:
Step 3:
Wall Mount Round Showerhead
Shower
Shower
Wall Mount Round Showerhead
Step 4:
Step 5:
Step 6:
Wall Mount Round Showerhead
1. Remove the old shower head by using the channel lock pliers or monkey wrench. Be sure to turn the pliers counter-clockwise to loosen the old shower head. (Tip: Right is tight, left is loose.)
2. Remove the shower arm by turning it by hand counter-clockwise. Make sure you remember to apply putty or tape to the new arm. (Tip: Using teflon tape is less messy)
3. Apply teflon tape to the threading of the shower arm by wrapping it around the threads, go all the way around 3 or 4 times depending on the quality of the Teflon tape.
4. Install the new shower arm by going clockwise by hand until it is tight, then put painters tape around the arm and tighten the arm with the channel lock or monkey wrench.
5. Place Teflon tape around the threads on the showerhead and then place the showerhead onto the shower arm by turning the shower head clockwise after the shower arm is already in the wall.
Hand Held Shower Installation Instructions
Step 1:
Step 2:
Hand
Held
Shower
Hand Held Shower
Step 3:
Hand Shower Outlet Installation • Complete the outlet pipework ensuring it ends in an appropriate 15mm x 1/2" BSP female thread elbow.
Note: This fitting is not supplied as variations in installations require the selection of a suitable solder or compression fitting.
• Install the 'Wall Outlet', thread long male 1/2" BSP into the appropriate female fitting using PTFE tape to give a watertight joint.
Note: The thread can be cut to size if required. Make sure that all debris is removed from the connector and the section that has been cut is dressed correctly, before installation.
Shower Body Jets Installation Instructions
Step 1:
Body Sprays
Step 2:
installation
Find Out First
Get FontanaShowers emails of inspiration, new product releases, and more!