Fontana Commercial Automatic Wall Mount Brushed Gold Sensor Bathroom Faucet
The Fontana Commercial Automatic Wall Mount Brushed Gold Sensor Bathroom Faucet from FontanaShowers is ideal for those looking for an antique style faucet, but not overly decorated. With simple and elegant lines, this faucet is a perfect match for classic style bathrooms. It is made entirely of brass, wall mounted, with motion Sensors for Water Saving. The valve core material is ceramic for best performance and long lasting life time. It comes with ½" connections, complete with accessories and installation instructions.
Before you begin, please read the installation instructions below. Observe all local building and safety codes.
Unpack and inspect the touchless faucet for any shipping damages for any shipping damages. If you find damages, do not install.
Please note all showers must be installed by a professional and certified plumber otherwise warranty might be voided
Wall Mount Sensor Faucet Installations
Step 3: Remove the self-tapping screws (1) and slide the slurry mold (2) off the body.
Step 4: Make faucet water pipe and wire through mounting bracket, screw and secure spout to the mounting bracket, make sure the spout forwarding to vessel.
Step 5: Insert the escutcheon (3) into the spout and secure it with screw (4).
Step 6&Step7: Fix the control box Remove the cover (6) after loose the screws (7). Determine the installation location of control box (5) per rough-in, then drill holes and place sheath in it. Make the control box cling on the wall and outlet upturned, then fix the control box on the wall by screws (8), keep the control box parallel to the wall.
Step 8: Connect check valve (9) and outlet together, then connect the hose (10) and check valve (9). Put a bucket in the front of hose (10), turn on the check valve (9) completely and open the water supply. After the water flushing about 1 minute, make sure no leakage and turn off thewater supply.
Step 9: Connect hose (10) to the inlet of the value, then connect the outlet of valve and inlet (11) of spout assy.
Note: 1. Do not lost the washer of hose.
2. Please let user prepare check valve by themselves.
3. Do not confuse the inlet and outlet.
Step 10: Take out the battery box and loose the screws (12), place two “AA” batteries into the box according to the negative and positive pole mark on the cover of the battery box (13). Put the box in the particular groove in the valve box after tight the screws.
Note: Do not mistake the pole and mixture the new and used batteries.
Step 11: Finally, connect the red-green lines in solenoid valve and cover of valve box, then connect the black-orange lines in power supply and control board ( If you faucet is AC version, please let the black-green line in the control board through the “U” gap and connect with theline of AC power box). Connect the red and white connectors in the sensor line and cover, and tight the box(5) and cover(6) by screws(7).
Step 12: Note: 1. When install the box and cover by screws, make sure the sensor line need to be through “U”Gap of cover.
2. Connect the batteries, faucet will be in the period of automatic adjusting sensing distance (about 2minutes). The faucet will not work during this period.