How to install Phone Controlled Fontana Valence Ceiling Mount Matte Black Thermostatic Music Smart LED Rain Shower Panel System With Massage Jets And Hand Sprayer | FS1466
Easy step by step Installation Instructions for Fontana Phone Control Music Rainfall Shower Set
Before you begin, please read the installation instructions below. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you find damages, do not install.
Please note all showers must be installed by a professional and certified plumber otherwise warranty might be voided.
shower
Shower Head Installation Instructions
Step 1:
recessed
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7: (LED Control Box)
Step 8:
Spout & Hand Held Shower Installation Instructions
Step 1:
Step 2:
HandHeld Shower
Hand Held Shower
Handheld Shower
Step 3:
Step 4:
Hand Shower Elbow Installation
• Complete the outlet pipework ensuring it ends in an appropriate 15mm x 1/2" BSP female thread elbow. Note: This fitting is not supplied as variations in installations require the selection of a suitable solder or compression fitting.
• Install the 'Wall Outlet', thread long male 1/2" BSP into the appropriate female fitting using PTFE tape to give a watertight joint. Note: The thread can be cut to size if required. Make sure that all debris is removed from the connector and the section that has been cut is dressed correctly, before installation.
1. Attach the escutcheon to the supply elbow. 2. Apply Teflon tape to the threaded tailpipe of supply elbow. 3. Screw the supply elbow into the female fitting of water supply. 4. Press the escutcheon against the finished wall.
Hand Shower Wall Bracket Installation
Decide the position for the shower head holder on the wall within the bath showering area and proceed as follows: • Hold the hand shower head holder fixing plate in a suitable position on the wall, mark out the position of the holder. Mark the two locating holes. • Drill and plug the wall. Use an appropriate masonry drill, but if the wall is plasterboard or a soft building block, use special wall plugs and an appropriate drill bit. • Slide the inserts onto the screws in the orientation. Secure the inserts by tightening the screws. • Slide the hand shower head holder body onto the inserts and secure by tightening the grub screw facing down.
