Installation Instructions for Luxury LED Rainfall Thermostatic Music Shower System 16x16 Inch
Before you begin, please read the installation instructions below. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you find damages, do not install.
Please note all showers must be installed by a professional and certified plumber otherwise warranty might be voided.
shower
Shower Head Installation Instructions
LED Remote Control
remote control
Bluetooth Connection Steps
24 Button infrared Bluetooth RGB Controller
Size Parameters
Note: 1. The power supply voltage of this product is DC5V-24V, it must not be connected to other voltages. 2. The lead wires should be correctly wired according to the colors and labels provided in the wiring diagram. 3. This product cannot be overloaded. 4. If you cannot search for the LED controller and cannot connect with the Bluetooth device, please turn off Bluetooth in your phone settings & turn back on and then connect again. 5. If you cannot connect to the device for a long time or other abnormality, please close the application and try to Restart. 6. Do not place the LED Bluetooth controller in a closed place with high temperature, humidity or water. 7. Non-professionals do not open the closing device at will.
Step 1:
Step 2:
showerhead
LED Shower Head Installation Instructions
Step 3:
Step 4:
According to the dimensions and shape of the mounting bracket, determine the bracket location to be installed in the ceiling.
According to the 8 mounting holes on the mounting bracket, use an Electric drill to make the mounting holes.
Shower Head Installation Instructions
Step 5:
Step 6:
Using the two hexagonal nuts adjust the distance between the mounting bracket and the ceiling, and keep the mounting bracket on the level. Use an explosion screw to fix the mounting bracket on the ceiling, pay attention to the explosion screw, it can adjust the height and use level tool to adjust the mounting bracket to reach level.
Connecting Circuits
Shower Head Installation Instructions
Step 7:
Step 8:
According to the chart shows: Raise the showerhead, Aim at the hole of the bolt, plug the bolt.
Use a Phillips screwdriver screw out the upper cover 4 screws, open the plastic waterproof boxes. Note: The same color line docking, brown line for line, the blue line is zero line. Use a Phillips screwdriver screw out the screws in plastic waterproof box wiring position, then put the fork terminal line connected, then fix it with a Phillips screwdriver.
Shower Head Installation Instructions
Step 9:
Step 10:
According to the circuit diagram as shown in step 5, then connect plastic waterproof case, please note that the same color of the wire when connecting circuit to docking.
Connecting water hoses and Tee joints and then connect the water hoses to the water inlet pipe connector.
