The advanced sensor technology dispenses a predetermined volume of liquid soap – not much, not really too little – reducing pollution and saving you money on product prices. Otto's dual LED signs illuminate when the electricity is turned on and when the battery is running low. Its specific sensor and faster motor speed enable it to dispense cleaner or sanitizer in 0.2 seconds. Otto's latest and updated system has a drip-free spout, which eliminates clutter and waste. Because of its wide funnel and high volume, it needs less frequent and time-consuming replenishing.
If the blue light illuminates and you feel the pump but the soap doesn't really dispense after inserting the batteries, consider dumping the soap into a different tub, then filling the pump of hot (not boiling) water and allowing it to rest for 5-10 minutes. Place your hand next to the motion sensor again and again until the water begins to flow freely. Now, drain the water and re-soap the pump. If you think that the soap you bought is too thick, consider adding some water to thin it out. The Otto Automatic Soap Pump cannot be used for foaming hand soaps, spray sanitizers, or soaps containing exfoilants.
Please ensure that the dispenser has an indicating blue light switched on. To get the best efficiency, clean Otto's dispensing tip on a daily basis and operate the pump with a warm plastic container. If you're using a thick hand cleaner, try diluting it with water. Otto's latest configuration provides a seal for its non-drip spout to reduce clogging and avoid sloppy drips, while the fluid level indicator window and big top-load opening make cleaning easier.
