How to install Fontana Toulouse Phone Controlled Stainless Steel LED Smart Music Rainfall Thermostatic Shower Head With Massage Jets And Hand Sprayer In Matte Black | FS1463
Installation Instructions for Bathroom Shower Set
Visit Product Page
Before you begin, please read the installation instructions below. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you find damages, do not install.
Please note all products must be installed by a professional and certified plumber otherwise warranty might be voided.
shower
Shower Head Installation Instructions
Step 1:
recessed
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7: (LED Control Box)
Step 8:
Spout & Hand Held Shower Installation Instructions
Step 1:
Step 2:
HandHeld
Shower
Hand Held Shower
Handheld Shower
Step 3:
Hand Shower Elbow Installation
• Complete the outlet pipework ensuring it ends in an appropriate 15mm x 1/2" BSP female thread elbow. Note: This fitting is not supplied as variations in installations require the selection of a suitable solder or compression fitting.
• Install the 'Wall Outlet', thread long male 1/2" BSP into the appropriate female fitting using PTFE tape to give a watertight joint. Note: The thread can be cut to size if required. Make sure that all debris is removed from the connector and the section that has been cut is dressed correctly, before installation.
1. Attach the escutcheon to the supply elbow. 2. Apply Teflon tape to the threaded tailpipe of supply elbow. 3. Screw the supply elbow into the female fitting of water supply. 4. Press the escutcheon against the finished wall.
Hand Shower Wall Bracket Installation
Decide the position for the shower head holder on the wall within the bath showering area and proceed as follows: • Hold the hand shower head holder fixing plate in a suitable position on the wall, mark out the position of the holder. Mark the two locating holes. • Drill and plug the wall. Use an appropriate masonry drill, but if the wall is plasterboard or a soft building block, use special wall plugs and an appropriate drill bit. • Slide the inserts onto the screws in the orientation. Secure the inserts by tightening the screws. • Slide the hand shower head holder body onto the inserts and secure by tightening the grub screw facing down.
Shower Body Jets Installation Instructions
Step 1:
Step 2:
body spray
Step 3: (Pressure Balancing Loop)
Rough-in Suggestion: This installation requires a 1/2" male threaded pipe fitting to extend 1/4" beyond the finished surface. The plumber should install a properly anchored 1/2" female pipe fitting (i.e. a drop-ear ell) recessed into the wall, into which a brass pipe nipple of proper length can be fitted once the finished wall is complete. Note: The hole size opening should be 1.5" max diameter.
Bodyspray placement: Custom shower systems are sized to the user or users. Bodysprays are normally placed at the upper back, middle back, and upper thigh. Always position bodysprays according to the preferences of the user(s).
Pressure Balancing Loop: If installing bodysprays in a bank of 3 or fewer, a pressure balancing loop is not necessary. If installing bodysprays in a bank of 4 or greater, a pressure balancing loop must be used to keep the pressure even between the bodysprays.
Instructions
Body jets should be arranged in your system to provide the necessary spray outlets to suit the application. 1. Identify all components and check for completeness, particularly before arranging fitting. 2. Depending on the application the body jet can be panel mounted using a backnut (not supplied) or set into the wall on rigid pipe work. If panel mounting care should be taken to ensure connection can be made after securing with the backnut. 3. Connect body jet to pipe work using recommended ½” BSP connections (not provided) with thread sealing compound where necessary. Note: - Before finishing wall turn on water supplies to check both correct system function and for leaking from joints/connections. 4. Complete wall finish.
Fontana Toulouse Phone Controlled Stainless Steel LED Smart Music Rainfall Thermostatic Shower Head With Massage Jets And Hand Sprayer In Matte Black
The Fontana Toulouse Phone Controlled Stainless Steel LED Smart Music Rainfall Thermostatic Shower Head with Massage Jets and Hand Sprayer in Matte Black is perfect to complement today's modern home. This Smart LED Musical Shower Set was designed to bring a modern and fun feel into any bathroom. Built from premium materials and finished with elegance. You may even have more time to enjoy your shower with a rainfall feeling. Easy-to-install and leak-free. The design was inspired by the FontanaShowers. Be sure, when it comes to new bathroom sink faucets, FontanaShowers is offering shape, finish and styles you're looking for.