Home > Installation Instructions For Fontana Reno Wall Mount Rose Gold Rainfall Mixer Shower Set

How to install Fontana Reno Wall Mount Rose Gold Rainfall Mixer Shower Set | FS9568


Easy step by step Installation Instructions for Thermostatic Rain Waterfall Shower Set
Visit Product Page
  • Before you begin, please read the installation instructions below. Observe all local building and safety codes.
  • Unpack and inspect the products for any shipping damages. If you find damages, do not install.
  • Please note all products must be installed by a professional and certified plumber otherwise warranty might be voided.
shower Fontana Reno Wall Mount Rose Gold Rainfall Mixer Shower Set

Shower Head Installation Instructions



Step 1: Step 2:
shower
Remove the protective cover (F). Mark the positions and drill holes to suit the anchors (A). Install the anchors (A) and fix the rough-in valve (B) into the wall with screws. Use a level to ensure that the rough-in valve (B) is straight and level. (Important: Flush the water supply to remove any dirt and debris before installing the valve body).
Wrap Teflon tape around the pipe threads and connect water supply lines and in-wall pipes (not included) as desired to the rough-in valve (B). Turn on the water supply and open the cartridge to check for leakage. Then put on the protective cover and finish the wall surrounding the valve. (Note: Test the water pressure after the pipe connections have been made and before the finished wall material is installed).
Shower Head Installation Instructions
Step 3: Step 4:
Fix the escutcheon (D) to the showerhead (E) with screws (C).
Remove the protective cover when the finished wall is completed. Then, install the showerhead (E) and press it against the finished wall.
Shower Head Installation Instructions




Hand Held Shower Installation Instructions


Elbow Size Step 1:
Hand
Held
Shower
Hand
Held
Shower

Handheld Shower
Step 2: Step 3:
Handheld Shower
Step 4: Hand Shower Size:

Hand Shower Elbow Installation

• Complete the outlet pipework ensuring it ends in an appropriate 15mm x 1/2" BSP female thread elbow.
Note: This fitting is not supplied as variations in installations require the selection of a suitable solder or compression fitting.

• Install the 'Wall Outlet', thread long male 1/2" BSP into the appropriate female fitting using PTFE tape to give a watertight joint.
Note: The thread can be cut to size if required. Make sure that all debris is removed from the connector and the section that has been cut is dressed correctly, before installation.

1. Attach the escutcheon to the supply elbow.
2. Apply Teflon tape to the threaded tailpipe of supply elbow.
3. Screw the supply elbow into the female fitting of water supply.
4. Press the escutcheon against the finished wall.


Hand Shower Wall Bracket Installation

Decide the position for the shower head holder on the wall within the bath showering area and proceed as follows:
• Hold the hand shower head holder fixing plate in a suitable position on the wall, mark out the position of the holder. Mark the two locating holes.
• Drill and plug the wall. Use an appropriate masonry drill, but if the wall is plasterboard or a soft building block, use special wall plugs and an appropriate drill bit.
• Slide the inserts onto the screws in the orientation. Secure the inserts by tightening the screws.
• Slide the hand shower head holder body onto the inserts and secure by tightening the grub screw facing down.




Shower Thermostatic Mixer Installation Instructions

Step 1: Step 2:
Shower
Mixer
Shower Mixer
Step 3:






Fontana Reno Wall Mount Rose Gold Rainfall Mixer Shower Set

Give your bathroom an elegant glance with a rain shower set. A single lever bathroom shower in a rose gold finish is the perfect complement to today's modern home. This Reno sanitary ware wall mount complete rose gold head, hand bath rain shower mixer set provides a luxurious showering experience and is the perfect complement to any modern bathroom. The modern design handheld a shower, cold and hot water shower mixer and an easy-to-use mixer valve, made from high-quality solid brass. Be sure, when it comes to the new bathroom rain shower set, FontanaShowers is offering shape, finish, and styles you're looking for.


Features:

  • Brand Name: FontanaShowers
  • Model Number: FS9568
  • Surface Finish: Rose Gold
  • Exposed Shower Feature: Without Slide Bar
  • Style: Contemporary
  • Valve Core Material: Brass
  • Material Analysis: CU ≥ 59%
  • Color: Rose Gold
  • Number of Handle: Single Handle
  • Type: Bath & Shower set
  • Function: Cold / HOT Water
  • Water Flow: Bath/Shower Mixer ≥ 18 L/min, Other mixers ≥ 12 L/mix
  • Air Pressure Testing: 0.6 Mpa
  • Water Pressure Testing: 1.6 Mpa
  • Fontana Reno Wall Mount Rose Gold Rainfall Mixer Shower Set