BISERENIQUE™ MATTE BLACK PRESTIGE SERIES
Fontana BiSerenique Matte Black Faucet FAQs
Matte black three-hole basin faucet with 304 stainless-steel
construction, brass valve core, twin crystal handles
and independent hot/cold water control.
✥
Three-Hole Deck Preparation?
+
The FS20025MB requires three deck openings
for the central spout and two independent
crystal-handle controls. Verify mounting
centers, countertop thickness, basin
clearance and below-deck fastening access
against the manufacturer installation drawing
before countertop fabrication.
◇
Stainless-Steel Body Construction?
+
The BiSerenique incorporates a 304
stainless-steel body with a matte black
exterior finish. Confirm mounting-gasket
positioning, spout alignment and secure
mechanical fastening during installation.
Protect the surface from abrasive tools
and excessive tightening forces.
◯
Crystal Handle Operation Checks?
+
Two colour-crystal handles independently
regulate hot and cold water delivery.
During commissioning, verify correct
supply identification, smooth handle
travel, predictable temperature mixing
and complete valve shutoff. Ensure both
handles have unobstructed clearance
throughout their operating movement.
↻
Cartridge Cycle Endurance?
+
The manufacturer specifies cartridge
durability of 500,000 opening and closing
cycles. Inspect for increasing operating
resistance, persistent dripping or
incomplete valve closure during routine
servicing. Actual cartridge life depends
on water quality, usage frequency and
operating conditions.
⌁
Water Pressure Testing Parameters?
+
The published water-pressure test value
is 1.6 MPa. This represents the stated
manufacturer test condition rather than
the allowable continuous operating-pressure
range. Confirm permissible supply pressure
using the current technical specification
before commissioning the installation.
⌂
Air Pressure Test Verification?
+
The product specification identifies
air-pressure testing at 0.6 MPa.
Following installation, inspect accessible
supply connections, valve interfaces
and sealing points for leakage using
the approved plumbing commissioning
procedure. The factory testing value
is not an onsite test instruction.
⚙
Brass Valve Core Troubleshooting?
+
The faucet uses a brass valve core
for mechanical water regulation.
Flush hot and cold supplies before
completing the final connections.
If irregular flow or persistent
dripping occurs, isolate the supplies
and inspect the valve components for
sediment, wear or incomplete seating
according to the service instructions.
⌕
Matte Black Finish Maintenance?
+
Clean the matte black surface and
decorative crystal handles with a soft
damp cloth and a compatible mild cleaner.
Avoid abrasive pads, polishing compounds,
acidic detergents and aggressive chemicals.
Rinse and dry exposed surfaces to reduce
mineral accumulation and maintain the
uniform matte appearance.
‹
›
Matte Black
Matte Black
Chrome
Brushed Nickel
Gold
Brushed Gold
Rose Gold
Oil Rubbed Bronze
Champagne
Matte White
Gun Metal Gray
♧
304 Stainless
Faucet Construction
◇
Crystal Handles
Independent Water Control
⌁
Brass Valve
Mechanical Regulation
⚙
500K Cycles
Cartridge Durability
◇
Three-Hole
Deck Installation