Fontana Rainfall & Mist Shower Head Set With Shower Body Sprays
This generous 20" x 20" ceiling mounted shower head provides rainfall and mist options to enhance your showering experience. Three handle mixer includes water divider, on/off and thermostatic temperature control. Six body massage jets come in two sizes to choose from. Hand held shower provides additional massaging coverage where you need it most. Built-in hydro-powered device powers the LED lights, which provide visual shower temperature cues to reduce water waste. The lights will dim and brighten when you lower and raise the pressure so you can set the perfect mood, water, and lighting. When water temperature is ≤89 °F (≤32 °C), Blue color will show automatically. When water temperature is between 97 to 107 °F (36-42 °C), Green color will show automatically. When water temperature is between 109 to 122 °F (43-50 °C), Red color will show automatically. When water temperature is above 122 °F (>50 °C), Red color will flash immediately.
Fontana Rainfall & Mist Shower Head Set With Shower Body Sprays Features:
Before you begin, please read the installation instructions below. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you find damages, do not install.
Please note all showers must be installed by a professional and certified plumber otherwise warranty might be voided.
shower
SHOWER HEAD INSTALLATION INSTRUCTIONS
shower
Shower Head Installation Instructions
Step 1:
shower
Step 2:
According to the template (B) mark the location of the mounting holes (1). Use a drill with a 6mm bit to drill mounting holes into studs or blocking.
Install the mounting brackets (C) with the tapping screws (D1). Thread the shower bars (E) onto the mounting brackets, and the inlet hose (F) onto the water inlet.
Shower Head Installation Instructions
Step 3:
Step 4:
Attach the shower head (A) to the shower bars (E). Connect the inlet hose (F) to the showerhead.
Shower Head Installation Instructions
Step 5:
HAND-HELD SHOWER INSTALLATION INSTRUCTIONS
Step 1:
Step 2:
Hand
Held
Shower
Hand Held Shower
Handheld Shower
Step 3:
SHOWER BODY JETS INSTALLATION INSTRUCTIONS
Body Sprays Installation Instructions
Step 1:
Step 2:
Body
Sprays
Set the decorative cover on the body jet.
Roll the raw material belt in the thread screws.
Body Sprays Installation Instructions
Step 3:
Use a wrench to tighten 6 body jets on the water outlet holes.
Tighten it in a clockwise direction.
Attach the positioning bar to the rough-in body (4,5) with tapping screws. Mark the location of the mounting holes.
Remove the rough-in body and drill pilot holes at the locations marked in the previous step. Insert anchors.
Shower Valve Mixer Installation Instructions
Step 5:
Step 6:
Attach the rough-in body to the wall.
Connect the rough-in body to the water supply pipes according to the diagram.
Shower Valve Mixer Installation Instructions
Step 7:
Step 8:
Finish the wall surrounding the shower with a thickness of 1/2"-1-1/2".
a) Finished wall surface should not exceed the upper edge of the installation box.
If the tile exceeds the edges of the installation box, trim the tile as necessary to install the trim plate.
b) Trim the tile around the installation box as necessary.
Shower Valve Mixer Installation Instructions
Step 9:
Remove the plastic guard and place the trim plate over the installation box. Install the screws covers, handles and buttons.
Shower Valve Mixer Installation
How to install the Shower Set with Wall Mount Showerhead, Hand Held Shower and Shower Mixer
