Fontana Bolln Rose Gold Rain Shower Head FAQ
2.5 GPM Testing, Finish Protection & Rainfall Spray Commissioning
This rose gold round shower head combines durable metal
construction, an 11-3/4-inch rainfall spray face, single-function
2.5 GPM discharge, and a standard threaded inlet for contemporary
residential, hospitality, and specification-driven shower projects.
How should the supply branch be flushed before fitting the shower head?
Remove the finished fixture and flush the open shower-arm branch
until solder residue, pipe scale, construction debris, and excess
sealing compound are fully discharged. Inspect the threaded outlet
before connecting the rose gold shower head.
How should the swivel joint be tightened without damaging the finish?
Apply thread sealant sparingly and tighten through the inlet
connection rather than gripping the finished outer body. Use a
protected tool surface, then adjust the swivel separately until
the 11-3/4-inch spray face is level.
How should the specified 2.5 GPM output be field-tested?
Stabilize the dynamic supply pressure, purge trapped air, and
perform a timed volumetric collection test at the shower head.
Low delivery may indicate branch pressure loss, debris restriction,
mineral accumulation, or blockage within the internal flow path.
How should the rose gold spray face be cleaned after commissioning?
Wipe the finished surface with a soft damp cloth and use only a
mild, non-abrasive cleaner when required. Avoid acidic chemicals,
scouring pads, and harsh descaling agents that may dull the finish
or damage the flexible rainfall nozzles.