FONTANA WALL-MOUNT™ LINE
Fontana Round Pin Wall-Mounted Faucet FAQs
Commercial wall-mounted basin faucet with round pin mixer,
1.32 GPM controlled flow, extended round spout geometry,
and coordinated architectural finish options.
✥
What Is The Faucet Projection?
+
The published faucet length ranges from approximately
7.48 to 8.27 inches. During rough-in coordination,
position the wall outlet so the discharge reaches the
intended basin impact zone without excessive splash
against the rear or front bowl surfaces.
◇
What Is The Rated Flow?
+
The Fontana wall-mounted round-pin mixer is rated at
approximately 5.0 liters per minute or 1.32 GPM.
Verify stable dynamic pressure and unobstructed outlet
flow during final commissioning.
◯
What Is The Spout Diameter?
+
The round wall-mounted spout has a published diameter
of approximately 1.65 inches. Confirm sufficient wall
clearance around the spout escutcheon and maintain
accurate alignment during concealed rough-in work.
↻
What Is The Outlet Angle?
+
The outlet is designed with an approximately 20-degree
downward discharge angle. Coordinate mounting height
and basin position so the water stream lands within the
primary wash zone while limiting splashback.
⌁
How Large Is The Mixer Assembly?
+
The round-pin handle unit is approximately 4.49 inches
high with a published wall-plate diameter of about
2.56 inches. Confirm adequate finished-wall space around
the mixer before closing the wall assembly.
⌂
What Installation Type Is Required?
+
This faucet is designed for wall-mounted installation.
Coordinate concealed supply piping, mixer depth,
finished-wall thickness, spout projection and basin
centerline before installing the final trim.
⚙
How Should The Mixer Be Commissioned?
+
Flush hot and cold supply lines before final connection,
verify correct supply orientation, operate the round-pin
mixer through its full range and confirm stable temperature,
unrestricted flow and complete shutoff.
⌕
What Routine Maintenance Is Recommended?
+
Clean the spout, mixer trim and wall plates with a soft
non-abrasive cloth, periodically remove mineral buildup
from the outlet, inspect concealed-service connections
where accessible and verify smooth mixer operation.
‹
›
Chrome
Renovation Needed Precision 
