Installation Instructions for Fontana Lima Luxury Stainless Steel Shower Set

Before you begin, read the installation instructions below. Observe all local building and safety codes.

Unpack and inspect for any shipping damages. If you find any damages, do not install. Contact Customer Service. If you need assistance while installing your shower system, call our Customer Service number.

We recommend consulting a professional if you are unfamiliar with installing bathroom fixtures and plumbing.

TOOLS AND MATERIALS:

• Screwdriver
• Teflon Tape
• Adjustable Wrench
• Smooth Joint Pliers
• Soft Cloth
• Silicone Sealant

INSTALLATION
1. Attach the upper wall support to the shower wall using a drill and the mounting hardware provided. Use a level to ensure that the shower riser is perfectly straight.
2. Place thread sealant on the ½” pipe threads in the shower wall and thread on the mounting nuts. Allow sealant to cure for 24 hours before use.
3. Attach the hot and cold valve bodies and decorative escutcheons (if included) directly to the pipe threads. Tighten with an adjustable wrench to secure.
4. To install a hand-held shower, mount the cradle at a suitable height for the user with the hardware provided. Attach the hose to the faucet with any rubber washers or sealing gaskets included. If your system does not feature a hand-held shower move on to the next step.
5. Attach the showerhead to the top of the riser and tighten with a smooth jaw wrench. Do not tighten more than ¼ turn beyond hand tight.
6. Turn on the water supply and open the faucet valves. Check for any leaks and verify that the hot and cold supplies are working correctly. Let the water flow through the riser pipe and shower hose for approximately 30 seconds to clear out debris and dirt.
Note: If leakage occurs, tighten connections with your adjustable wrench as necessary. If problems persist, contact Customer Service


Shower Head Installation

• Decorative cover
  
• Screws
  
• Pipe 1
  
• Pipe 2
  
• Screw
  
• Bolt
  
• Nut
  
• Water Inlet Pipe

Hole size on ceiling

1. Drawing the line on the ceiling according to the above specification
· Decorative Cover
· pipe 1

2. connect pipe 1 with decorative cover

3. Drill the holes on the ceiling according to the above hole specification and install 4 pipes. 4. According to the right drawing, install four-pipe 2 into pipe 1. Put the screw bolts through the hole on the side to lock pipe 2 with pipe 1.	5. As the right drawing is shown, install four-pipe 2 on the head shower. 6. After fixing the showerhead on the ceiling, connect the shower hose with 2 water inlet on the showerhead back cover. The other end connects with the water outlet pipe in the wall.

Remarks: Ceiling mounted shower head comes with fixing bar installation.
1. Draw size on ceiling

2. Install fixing bar on the ceiling

3. Install fixing bar on shower head

4. Put shower head bar on ceiling fixing bar.

The showerhead installation is now complete.

Body-Jet Installation

Install the Supply Piping