Installation Instructions Before installing, read entire Installation Instructions. Observe all local building and safety codes.
For the following Installation Instructions for your new product, it is assumed that any old fixtures have been removed and any repairs or modifications to the water supply have been completed. Unpack and inspect the product for any shipping damages. If you find damages, do not install it.
Contact Customer Service 703-378-2808, If you need assistance or have questions while installing your product, contact Customer Service.
We recommend consulting a professional if you are unfamiliar with installing bathroom fixtures
TOOLS AND MATERIALS:
Adjustable Wrench Silicone Sealant Damp Cloth
2. Attach the provided braided water lines to the faucet until hand tight.
3. Remove the brass lock nuts from the mounting posts, and attach the threaded mounting posts to the faucet body using a Philips screwdriver. Set the brass lock nuts aside for now
4. Set the faucet into its prepared mounting hole.
5. From below, slide the rubber washer onto the mounting posts followed by the metal washer. Hold in place.
6. Secure the faucet by reattaching the brass lock nuts that were removed in step 3. Hand tightens and adjust the faucet until it is properly aligned. Once aligned, use the provided basin wrench to finish tightening the locknuts.
7. Apply plumber’s tape or thread sealant to the threading on each braided water line. Attach the water lines to your main water supply. Ensure that you are connecting the hot and cold lines accordingly.
8. Once installation is complete, turn the main water supply back on from underneath your sink. Check for any leaks underneath.
9. Check to ensure that both cold and hot water running properly. Allow the water to flow for approximately 60 seconds to remove any dust or sediment within the waterlines.
