Fontana Warsaw Waterfall Shower & Rainfall LED Shower System
This complete waterfall shower system from FontanaShowers will exceed all expectations from aesthetics to function, longevity and everything in between. The shower head offers two options, waterfall and rainfall. Six large massage body shower jest Sprays that are adjustable body jets - perfect for a refreshing and rejuvenating shower after a long, tiring day. The handheld shower wand is a wonderful addition, giving you more versatility and flexibility with your showering choices. Built-in hydro-powered device powers the LED lights, which provide visual shower temperature cues to reduce water waste. Fontana Warsaw Waterfall & Rainfall LED Shower System change color by detecting water temperature. When water temperature is ≤89 °F (≤32 °C), Blue color will show automatically; When water temperature is between 97 to 107 °F (36-42 °C), Green color will show automatically; When water temperature is between 109 to 122 °F (43-50 °C), Red color will show automatically; When water temperature is above 122 °F (>50 °C), Red color will flash immediately. Be sure, when it comes to new bathroom rain shower faucets, FontanaShowers is offers the shape, finish and styles you're looking for.
Fontana Warsaw Waterfall & Rainfall LED Body Massage Shower System Features:
Shower Brand Name: FontanaShowers
Shower Model Number:FSNX-57-WATERFALL-SHOWER-FAUCE
1. Open the top cover and drill according to the marked position.
Mark by the position of the four holes.
Take care to avoid wires and pipes to prevent damage.
Be sure to confirm that the four holes are on the same horizontal line.
2. Two inlet fittings are connected to the pipe joint of the wall; then the nut, expansion screw, and inlet pipe are connected.
3. Reinstall the top cover. Hand Held Shower Installation
Parts List
A. Hand Shower
B. Wall Anchors (x2)
C. Screws (x2)
D. Wall Bracket
E. Cap
F. Hose
G. Screen Washer
Place the screen washer in the end of the handshower hose. Screw the hose to the handshower.
If the flow of water becomes noticeably less, remove and clean the screen washer.
Scale Removal
The handshower incorporates the cleaning system. If scale deposits are noticed in the spray channels, turn the water on lightly and rub the spray channels with a finger or a sponge.
If scale deposits are noticed on the spray face, pour about 3/4" of a commercial scale remover into a shallow dish. Dilute the remover according to the label instructions.
Soak only the spray face in the solution for the amount of time specified on the label.
Rinse the handshower with clear water.
Reinstall the handshower. Turn on the water and al-low the handshower to flush for at least one minute.
Body Sprays Installation
Parts Lis
A.Connector
B.Connector Screws (x2)
C.Bracket Screws (x4)
D.Bracket
E.Plaster Guard
F.Test Plug
G.Test Plug Nut
H.1/8" Hex Wrench
I.Housing
J.Housing Nut
K.Spray Assembly
L.Grease Packet
M.Trim Ring-Square
N.Trim Ring-Round
O.Set Screw
P.9/64" Hex Wrench
Q.1/16" Hex Wrench
R.Filter
1" Extension Service Kit
* Not Included
Rough-In Installation
5. Plumb the connector to water supply lines.
Rough-In Complete
Trim Installation
12. If distance is less than or equal to 2-1/8" (54mm), proceed to step 13. If distance is greater than 2-118", order 1" extension kit.
13 (A). Tighten housing nut (J) until housing (I) is secure and does not spin on wall.
14. Flush system before next step.
Reduced Flow Turn off water supply
To Re-install:
Reverse steps A through C, then turn on water supply.
The installations & illustrations for Rainfall LED Shower System are for informational purposes only. alt="BathSelect Ancient Round Antique Rainfall Wall ShoweBathSelect Ancient Round Antique Rainfall Wall Shower Head Installation Instructions Head Installation Instructions" width="100%" />